Wallpaper instructions

Pre pasted wallpaper
(with an intergrated adhesive layer!)

Step 1

The preparation. First, make sure the walls are smooth. Remove all wallpaper, adhesive residue and other blemishes. For a good result the surface should be completely smooth! Make sure that the floor is free and equipped with a waterproof sailing. During application of the photo wall murals you make use of water. As a result, there might be water on the floor.

Step 2

Draw a vertical line with a perpendicular / level.

Step 3

For this wallpaper you ONLY NEED WATER. The wallpaper has a pre-glued adhesive side on the back of the wallpaper. Place a container (at least 60 cm wide, or more when you choose wide panels) in the space where it is to be hung and fill it with water. Then place the roll in the water for 20 seconds.

Step 4

Carefully take the job out of the water and fold it in first on one side and then on the other side. (pay attention to the wallpaper immediately afterwards)

Step 5

Hang the first panels against the perpendicular. Make sure you use the right panel (number)! Lay the stroke down gently and (without too much pressure) smooth it out from the center to the sides.

Step 6
Then stick the next panel on the wall in the same way as the previous lane.
Step 7

Cut away all the extra material along the ceiling, the plinth and possibly the door jamb with the help of a wallpaper ruler or spatula and a sharp, new hobby knife.

Step 8
Remove excess glue residues from the wallpaper.

Non-woven wallpaper
(assemble with an adhesive made for non-woven wallpaper)

Step 1

The preperation. The preparation. First, make sure the walls are smooth. Remove all wallpaper, adhesive residue and other blemishes. For a good result the surface should be completely smooth! Make sure that the floor is free and equipped with a waterproof sailing. During application of the photo wall murals you might make a bit of a mess.

Step 2

Draw a vertical line with a perpendicular / level.

Step 3

For this wallpaper you should use wallpaper glue for non-woven wallpaper, a sharp knife, a squeegee and a level.

Step 4

Start with covering the wall(!) NOT the wallpaper with the adhesive for non-woven wallpaper.

Step 5

Hang the first panel against the perpendicular. Make sure you use the right panel (number)! Lay the stroke down gently and (without too much pressure) smooth it out from the center to the sides.

Step 6

Then stick the next panel on the wall in the same way as the previous lane.

Step 7

Cut away all the extra material along the ceiling, the plinth and possibly the door jamb with the help of a wallpaper ruler or spatula and a sharp, new hobby knife.

Step 8

Remove excess glue residues from the wallpaper.

Extra advice for the assembler!

  • Unless otherwise stated on the instruction included, you can stick this photo wallpaper.

  • The wallpaper always comes with a approx. 5 cm margin all around.

YouPri is not responsible for the pretreatment of the walls or the assambling of the wallpaper. As well as the occurrence of consequential and / or consequential damage before, after or during the application of the photo wallpaper.